selected data does not fit into selected flash sectors

A key disadvantage of flash memory is that it can endure only a relatively small number of write cycles in a specific block. NAND or NOR flash memory is also often used to store configuration data in numerous digital products, a task previously made possible by EEPROM or battery-powered static RAM.

The NAND type is found mainly in memory cards, USB flash drives, solid-state drives (those produced since 2009), feature phones, smartphones, and similar products, for general storage and transfer of data. A flash memory device typically consists of one or more flash memory chips (each holding many flash memory cells), along with a separate flash memory controller chip. NOR flash memory allows a single machine word to be written – to an erased location – or read independently. NAND flash memory, however, may be erased, written, and read in blocks (or pages), which generally are much smaller than the entire device. EPROMs had to be erased completely before they could be rewritten.

Toshiba began marketing flash memory in 1987.

They differ at the circuit level depending on whether the state of the bit line or word lines is pulled high or low: in NAND flash, the relationship between the bit line and the word lines resembles a NAND gate in NOR flash, it resembles a NOR gate.įlash memory, a type of floating-gate memory, was invented at Toshiba in 1980 and is based on EEPROM technology. Both use the same cell design, consisting of floating gate MOSFETs. The two main types of flash memory, NOR flash and NAND flash, are named for the NOR and NAND logic gates. launches/xxx.Flash memory is an electronic non-volatile computer memory storage medium that can be electrically erased and reprogrammed. It appears that this information may be contained in the files.

So whenever someone goes to cloned the repo again these setting get lost resulting in much time lost and frustration. I found this select box in the image below which works, however it does not modify any of the normal CCS project files (.ccsproject. The bootloader takes up sector A and the main code fills the other sectors.īy default CCS v7.2 will erase all sectors when starting a debug session and this ends up erasing either the bootloader or the main code. I have an implementation of a bootloader and main code.

Selected data does not fit into selected flash sectors